We use own and third party cookies. Continue browsing implies acceptance.More informationAccept

Deflex Injection System

Effectiveness and practicality

  • Maximum time saving
  • Powerful
  • Easy to install, easy to operate

There are three models of Deflex injection devices: MAD1300, MAD1400 and MD1500.
The MAD1300 and MAD1400 are automatic, and the MD1500 is semi-automatic.
Between automatic models the MAD1300 differs from the MAD1400 because it has preset programs and an injection block sensor.

CHARACTERISTICS OF DEFLEX INJECTION DEVICE

  • Pneumatic with integrated oven
    Unlike manual injectors, the strength and speed of the injection will always be the same, and not will depend on the operator who tampers with the equipment. This ensures a quality of consistency injected into each injected prosthesis.
    The oven is integrated with the pneumatic cylinder, which is not necessary to move the cartridge that is in place, saving time and avoiding possible problems of injection, which may arise from the transfer of the cartridge.
  • Fully automatic*
    Place the flask and cartridge, select the desired parameters, and activate the automatic cycle. Once the cycle is completed, the flask will already be injected, and available for a new injection.
    *Applies to MAD1300 and MAD1400 models
    *MAD1300 model has 7 pre-configured and 7 free programs. Selecttheprogramcorresponding to the material thatwill be injected, or set customprograms.
  • Compact, easy to install, ease to use
    MAD1300 and MAD1400 injectorshardly occupies an area of 15cm x 30cm. It only requires an air compressor, and access to an electrical outlet. The manipulation of the device is extremely intuitive.
    The flask adjustment system runs with a single movement and a single folding handle, saving operational time.
  • Powerful
    The pneumatic cylinder was developed with one wider diameter than the conventional, and drives a compressive strength of 862 Kg 6.5 Kg/cm2 = 1900 lb to 92.5 PSI, making it the most powerful in the market. This is not a minor technical detail, because the greater compaction forcebetter quality of the injection, giving as a result molecularly more compact materials, which facilitates the work of retouching and subsequent brightness obtaining.
  • Pre-heating of the flask during the injection cycle
    It doesn’t require that the flask is pre-heated in a separate oven. The flask is positioned on top of the oven at the beginning of the heating cycle, and is taking the appropriate temperature to avoid thermal shock with the injected material.
  • 6th Generation of Deflex injectors
    MAD1300 y MAD1400 modelsare the 6th generation of injectors manufacturer by Deflex in its 17-year history. It is the product of a continuous evolution, and an accumulation of experience in the specialized area of injected prostheses.
DEFLEX INJECTOR MAD1300MAD1300 MAD1400MAD1400 MD1500MD1500
Injectionmode Automatic Automatic Semi-Automatic
Injectioncylinder Pneumatic
Temperature Digital - Programmable
Air pressure Programmable
Oven Integrated oven
Programs 7 PRG pre-configured
7 PRG libres
1 PRG free No
 Maximum temperatura of use

Programable: 500ºC / 932ºF
Recomended:390ºC/734ºF 

Flaskcover YES YES No
Injection block sensor YES No No
Adjustinghandle 1
HxWxD 62cm x 15cm x 30cm 64cm x 20cm x 35cm
Weight 22Kg. / 48.5Lb.
Powersupply 220v o 110v
Diameter 22mm o 25mm
CE Certification YES YES No
Ask for availability of injectormodels, diameter and powersupply by country.